This is a typical view
of trailer hitch installed. This photo shows the rear of a Sprinter
without step bumper. If your Sprinter has a step bumper, we use a
different hitch that sits lower and slightly more rearward. These hitches
can be installed in about 45 minutes, and mount to the existing frame
The complete wiring
kit with brake control is shown above. It comes with everything you will
need to safely wire-up your Sprinter to allow you to tow most any trailer.
The Sprinter has some special considerations that must be addressed when
running and connecting wires.
Learn from our helpful
video above. The Sprinter requires some special steps to route and connect
the wiring for your trailer's lights and brakes. This video is a real time
and trouble saver.
Class III Hitch for Sprinter:
Before ordering, do you have:
1. a long Sprinter or short Sprinter
2. single or dual rear wheels
3. step bumper, or no step bumper.
Sprinter hitch wiring kit
including 7+4 pin connector, brake control and all installation hardware:
Sprinter hitch wiring kit with 4-pin flat style
connector with installation hardware: